Magnetic block heater, 120 AC, 60 Hrz, 200 watts.

Surface area is 2-1/4 x 3-3/4 inches.

Delivers 300 to 400 degree surface temperature at 2 AMP maximum draw.

KATS "HANDI-HEAT" model with a 6 foot cable.

Includes instructions and display box.

Applications include:

• Oil pan, intake manifold, battery holder or engine block.

• Snowblowers, chainsaws, snowmobiles, or other small engines.

• It may also be used for warming hydraulic systems or thawing frozen locks, pipes, gutters, livestock feeders, etc.

Kat's Magnetic Heaters Installation Application Instructions

1. Object to be heated must be a magnet attracting surface.

2. Surfaces to be heated must be clean and free of dirt, grease, or oil.

3. Heater must be placed on surface to be heated before plugging in.

For engine heating:  Best results can be achieved by sticking the heater on the lowest flat surface of the bottom or side of the oil pan.  Heater must be removed before operating vehicle unless it is permanently mounted to the oil pan.

Never touch heating surface, case temperature may exceed 150 degrees F. and the heating surface will range from 300 to 400 degrees F.