• Silicone Covered

• Acid Resistant

• Pliable

• For Cars, Truck, Tractors

• Use as Oil Pan Heater

• Use as Transmission Pan Heater

• Use on a Diesel Tank

• Use on a Hydraulic Tank or Water Tank

• Intake manifold, battery holder or engine block.

• Snowblowers, chainsaws, snowmobiles, or other small engines.

• It may also be used for warming hydraulic systems or thawing frozen locks, pipes, gutters, livestock feeders, etc.

• Easy to install!

• Includes instructions and display box.

• The pad is self-adhesive

• One year warrantee with Kat's

NOTE:  Not for use on batteries. Do not cut the pad.Always place heater on metal reservoir before plugging in heater.  Application ranges may vary depending on outside temperature.  Do not use pads with a higher than recommended wattage for specific capacities.

Click on Photos for larger image.

Application Instructions:

1. Clean & sand reservoir to bare metal.  Remove all dirt, grease, oil and other contaminants using a degreasing solvent.  do not use gasoline or acetone.

2. If heater is to be installed on a vehicle, try to run the engine to pre-warm the oil pan.

3. Peel off backing and apply pad to reservoir making sure that there are no air pockets or creases in the pad.  Use a roller or spreader to remove them.

4. Seal the edges of the heater with high temperature silicone to insure proper protection to the edge of the heater.

5. Secure the cord up and out of the ways of any obstructions, making sure that it does not hang down from the pan or touch any hot or moving part of the engine.

6. NOTE:  Do not cut pad;  Do not use on battery.

Glue to the bottom of your oil pan, etc.

For engine heating:  Best results can be achieved by sticking the heater on the lowest flat surface of the bottom or side of the oil pan.