Warehouse Auto Parts

Auto Parts Delivered Right to Your Door

1-530-262-1368

HOME     Web Specials     Parts Request     eBay Specials     Sitemap

Edelbrock

Equus Instruments

Grant

Kats Heaters

Kat's Heaters

Silicone Hot Pad Heater!

#24025

25 watt / 120 Volt

1.5" X 5" pad

Parche Caliente De Silicon

MSRP: $26.99

OUR PRICE: $16.49

$15.95

Click on Image for larger view.

Electrical cords are 5'.

In Cold Freezing Weather, Protect your Vehicle Motor  or equipment by Keeping your liquids from getting too Thick or freezing!!

 

• Silicone Covered

• Acid Resistant

• Pliable

• For Cars, Truck, Tractors

• Use as Oil Pan Heater

• Use as Transmission Pan Heater

• Use on a Diesel Tank

• Use on a Hydraulic Tank or Water Tank

• Intake manifold, battery holder or engine block.

• Snowblowers, chainsaws, snowmobiles, or other small engines.

• It may also be used for warming hydraulic systems or thawing frozen locks, pipes, gutters, livestock feeders, etc.

• Easy to install!

• Includes instructions and display box.

• Silicone Adhesive Not Included

• One year warrantee with Kat's

NOTE:  Not for use on batteries. Do not cut the pad. Always place heater on metal reservoir before plugging in heater.  Application ranges may vary depending on outside temperature.  Do not use pads with a higher than recommended wattage for specific capacities.

Click on Photos for larger image.

	100 Watts	150 Watts	250 Watt	500 watts
Engine  Oil Pan	2-5 quarts	5-8 quarts	8-20 quarts	20-35 quarts
Diesel Tank	5-7 quarts	7-10 gallons	10-20 gallons	20-30 gallons
Hydraulic Tank	1-5 gallons	5-10 gallons	10-20 gallons	20-30 gallons
Water Tank	0-2 gallons	2-4 gallons	4-7 gallons	7-10 gallons

 

Application Instructions:

1. Clean & sand reservoir to bare metal.  Remove all dirt, grease, oil and other contaminants using a degreasing solvent.  do not use gasoline or acetone.

2. If heater is to be installed on a vehicle, try to run the engine to pre-warm the oil pan.

3. Peel off backing and apply pad to reservoir making sure that there are no air pockets or creases in the pad.  Use a roller or spreader to remove them.

4. Seal the edges of the heater with high temperature silicone to insure proper protection to the edge of the heater.

5. Secure the cord up and out of the ways of any obstructions, making sure that it does not hang down from the pan or touch any hot or moving part of the engine.

6. NOTE:  Do not cut pad;  Do not use on battery.

Glue to the bottom of your oil pan, etc.

For engine heating:  Best results can be achieved by sticking the heater on the lowest flat surface of the bottom or side of the oil pan.